Kubota K008-5 User Manual

146 W9215-8135-1
06/2021
Maintenance
Crawler tension - check
 The crawler seam (1) is half way between the idler and sprocket .
 Check the crawler sag as shown in the figure.
Crawler sag "A" 10-15 mm
 If the crawler sag is more than 15 mm, adjust the crawler.
 If necessary, tighten or loosen the crawler.
 Start the engine and rotate the lifted crawler briefly.
 Recheck the crawler tension, readjusting it if necessary.
 Perform the procedures on the second crawler.
Crawler tension - adjust
Tightening the crawlers
 Position the grease gun on the grease nipple (1).
 Pump the grease gun until the specified crawler tension is ob-
tained.
If the crawlers are too tight, wear is increased.
If the crawlers are too loose, wear is increased and the crawlers may come off.
Caution: The area around the rotating crawler must be free of persons. Turn the starter switch to the
STOP position after turning and remove the key.
STOP

Kubota K008-5 Specifications

General

Make	Kubota
Model	K008-5
Category	Compact Excavator
Bucket Capacity	0.022 m³
Max Dig Depth	1720 mm
Max Dump Height	2.43 m
Overall Length	2.75 m
Overall Width	700 mm
Fuel Tank Capacity	12 L