Lantronix SLC 8000 Series User Manual

7: Services
SLC™ 8000 Advanced Console Manager User Guide 129
Figure 7-7 SSH or Telnet CLI Session
To directly access a specific port on a particular device:
1. You have two options:
 Dashboard
Make sure the WebSSH (DP only) radio button directly beneath the Dashboard is
selected and click the desired port number. The Dashboard is located on the upper right
corner of each Web Manager page (see Chapter 5: Web Page Layout.) An SSH popup
window appears.
Note: WebTelnet is not available from the Dashboard. See Dashboard on
page 63 as the dashboard may vary in appearance.
 Secure Lantronix Page
Click the Services tab, then click the Secure Lantronix Network link (see Figure 7-4.)
Select the port you want to configure. Enabled port numbers are in bright green boxes and
will allow you to select either a WebSSH or a WebTelnet session. If enabled, an SSH or
Telnet popup window appears depending on what is clicked. For SLC console managers
with 7.2.0.0 firmware releases and earlier, an SSH or Telnet popup window for Java
appears (see Figure 7-6) before login. Click OK to dismiss this popup window and
continue on to the login. For SLC console managers with 7.3.0.0 firmware releases and
later, the SSH or Telnet popup window is bypassed and you are brought directly to the
login in a non-Java based window (see Figure 7-7). For tips on troubleshooting browser
issues for the non-Java based Web SSH/Telnet application, see Troubleshooting Browser
Issues (on page 131).
Note: Port numbers that are disabled are in dark green boxes; clicking a
disabled port number generates a popup window indicating the port is disabled
(see Figure 7-8 below.)

Lantronix SLC 8000 Series Specifications

General

Brand	Lantronix
Model	SLC 8000 Series
Category	Switch
Language	English