Lantronix SLC 8000 Series User Manual

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 393
Routing Commands
set routing
Syntax
set routing [parameters]
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names (enable).
You can optionally email the displayed information.
RPM Commands
set rpm add
Syntax
set rpm add <RPM Name>
Description
Adds an RPM to be managed (prompts will guide selection of RPM vendor and model).
set RPM command
Syntax
set rpm command <RPM Id or Name>
outlet <all|Outlet # or List> state <on|off|cyclepower>

Lantronix SLC 8000 Series Specifications

General

Brand	Lantronix
Model	SLC 8000 Series
Category	Switch
Language	English