Lantronix SLC 8000 Series User Manual

9: Device Ports
SLC™ 8000 Advanced Console Manager User Guide 162
Figure 9-5 Device Ports > Settings (2 of 2)
2. Enter the following:
Device Port Settings
Port Displays number of port; displays automatically.
Mode The status of the port; displays automatically.
USB Device This field is only displayed for USB ports. If a USB device is connected to the
device port, this displays the USB version, speed, and a short type description for
the USB device. The SLC supports up to 48 USB type A (Host) devices at data
rates of HS (480 Mbit/s), FS (12 Mbit/s) or LS (1.5 Mbit/s). Each port has VBUS 5V
support of up to 100mA (but not too exceed 600mA total per 16-port USB I/O
module). Drawing more than 150 mA on a USB device port will shut down the
VBUS 5V. USB ports are designed for data traffic only, and are not designed for
charging or powering devices. Overcurrent conditions may disrupt operations.
Name The name of the port. Valid characters are letters, numbers, dashes (-), periods,
and underscores ( _ ).
Detect Port Name If enabled, the SLC will attempt to detect the hostname of the device connected to
the device port, and set the device port name to the detected hostname. Many
devices use their hostname or another identifier as the device prompt, and the SLC
can extract this name from the prompt using the Detect Name Tokens.
If the device port name is set to the default value, when a user interacts with a
device connected to a device port, the SLC will look for the device prompt and set
the device port name. The device prompt must be output at least 3 times in a single
session for the prompt to be detected and the name extracted from the prompt.
Any characters that are not part of the allowed characters for the device port Name
will be removed. If the device name is automatically detected, the name will be
logged in the Device Ports log.

Lantronix SLC 8000 Series Specifications

General

Brand	Lantronix
Model	SLC 8000 Series
Category	Switch
Language	English