9: Device Ports
SLC™ 8000 Advanced Console Manager User Guide 183
3. Click the Apply button to save the changes.
Console Port Commands
Go to Console Port Commands to view CLI commands which correspond to the web page entries
described above.
Internal Modem Settings
This section describes how to configure an internal modem in the SLC advanced console
manager. The SLC 8000 internal modem is an optional part. If the modem is installed, a message
will be displayed when the SLC unit is booted:
Internal modem installed.
The presence of the modem will also be displayed in the CLI admin version command, the
web About SLC page, and the System Configuration report. The internal modem provides a
subset of the modem functionality available for modems connected to a Device Port and USB
modems. If the internal modem is installed, the Internal Modem web page can be displayed by
selecting the Internal Modem option from the main menu, or by selecting the MD button in the
Sample Dashboards on the upper right corner of the web page.
Note: The internal modem only supports Dial-in, Dial-out and Dial-back.
Setting Up Internal Modem Storage
An internal modem may be configured on the Devices > Internal Modem page and accessed
through the Sample Dashboards only if it is installed into the SLC 8000 advanced console
manager. .
To set up internal modem storage in the SLC 8000 advanced console manager:
1. Insert an internal modem into the SLC unit according to the instructions in Modem Installation
(on page 43).
Parity Parity checking is a rudimentary method of detecting simple, single-bit errors.
From the drop-down list, select the parity. The default is none.
Flow Control A method of preventing buffer overflow and loss of data. The available methods
include none, xon/xoff (software), and rts/cts (hardware). The default is none.
Timeout The number of minutes (1-30) after which an idle session on the console is
automatically logged out. Disabled by default.
Show Lines on
Connecting
If selected, when you connect to the console port with a terminal emulator, you will
see the last lines output to the console, for example, the SLC boot messages or
the last lines output during a CLI session on the console.
Group Access If undefined, any group can access the console port. If one or more groups are
specified (groups are delimited by the characters ' ' (space), ',' (comma), or ';'
(semicolon)), then any user who logs into the console port must be a member of
one of the specified groups, otherwise access will be denied. Users authenticated
via RADIUS may have a group (or groups) provided by the RADIUS server via the
Filter-Id attribute that overrides the group defined for a user on the SLC 8000
advanced console manager. A group provided by a remote server must be either a
single group or multiple groups delimited by the characters ' ' (space), ',' (comma),
';' (semicolon), or '=' (equals) - for example "group=group1,group2;" or
"group1,group2,group3".
To Next Page
Loading...
Need help?
General
