12: User Authentication
SLC™ 8000 Advanced Console Manager User Guide 284
3. Select or clear the checkboxes for the following rights:
4. Click the Add Group button.
Escape Sequence A single character or a two-character sequence that causes the SLC 8000
advanced console manager to leave direct (interactive) mode. (To leave
listen mode, press any key.)
A suggested value is Esc+A (escape key, then uppercase "A" performed
quickly but not simultaneously). You would specify this value as \x1bA, which
is hexadecimal (\x) character 27 (1B) followed by an A.
This setting allows the user to terminate the
connect direct command
on the command line interface when the endpoint of the command is
deviceport, tcp, or udp.
Break Sequence A series of one to ten characters users can enter on the command line
interface to send a break signal to the external device. A suggested value is
Esc+B (escape key, then uppercase “B” performed quickly but not
simultaneously). You would specify this value as \x1bB, which is
hexadecimal (\x) character 27 (1B) followed by a B.
Custom Menu If custom menus have been created you can assign a default custom menu
to the group. See Custom Menus for more information.
Display Menu at Login Check the checkbox to display the menu at login.
Full Administrative Right to add, update, and delete all editable fields.
Networking Right to enter Network settings.
Services Right to enable and disable system logging, SSH and Telnet logins, SNMP, and
SMTP.
Secure Lantronix
Network
Right to view and manage Secure Lantronix units (e.g., Spider, or SLC units) on
the local subnet.
Date/Time Right to set the date and time.
Reboot & Shutdown Right to shut down and reboot the SLC unit.
Local Users Right to add or delete local users on the system.
Remote
Authentication
Right to assign a remote user to a user group and assign a set of rights to the user.
SSH Keys Right to set SSH keys for authenticating users.
User Menus Right to create a custom user menu for the CLI.
Web Access Right to access Web-Manager.
Diagnostics &
Reports
Right to obtain diagnostic information and reports about the unit.
Firmware &
Configuration
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Internal Modem Right to update internal modem settings.
Device Port
Operations
Right to control device ports.
Device Port
Configuration
Right to enter device port settings.
USB Right to enter modem settings for USB devices and control USB storage devices.
SD Card Right to enter settings for SD card.
RPM Right to manage and control remote power managers.
To Next Page
Loading...
Need help?
General
