EasyManuals Logo
Home>Lantronix>Switch>SLC 8000 Series

Lantronix SLC 8000 Series User Manual

Lantronix SLC 8000 Series
425 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #368 background imageLoading...
Page #368 background image
15: Command Reference
SLCâ„¢ 8000 Advanced Console Manager User Guide 368
sshtimeout <disable|1-3600 seconds>
stopbits <1|2>
sysloglogging <enable|disable>
tcpauth <enable|disable>
tcpdatadir <netin|netout|both>
tcpin <enable|disable>
tcpport <TCP Port>
tcptimeout <disable|1-3600 seconds>
telnetauth <enable|disable>
telnetdatadir <netin|netout|both>
telnetin <enable|disable>
telnetport <TCP Port>
telnetsoftiac <enable|disable>
telnettimeout <disable|1-3600 sec>
termstr <Termination String>
timeoutlogins <disable or 1-30 minutes>
tokenaction <List of none,log,trap,email,string,power>
tokendatadetect <enable|disable>
tokenstring <Regex String>
tokentrigger <bytecnt|charstr>
usbchannel <1-2>
usblogging <enable|disable>
usbmaxfiles <Max # of Files>
usbmaxsize <Size in Bytes>
usbport <U1|U2|SD>
usbvbus <enable|disable>
usesites <enable|disable>
viewportlog <enable|disable>
Description
Configures a single port or a group of ports.
Set the modem password and CHAP secrets (any extra parameters will be ignored):
set deviceport port <Device Port # or List or Name> dialoutpassword
set deviceport port <Device Port # or List or Name> chapsecret
set deviceport port <Device Port # or List or Name> dodchapsecret
Reset a device port, terminating and restarting all relevant connections:
set deviceport port <Device Port # or List or Name> reset
Configure up to 4 managed power supplies for device connected to a device port:
set deviceport port <Device Port # or Name> managepower
Reset a device port, terminating and restarting all relevant connections:
set deviceport port <Device Port # or List or Name> reset
Note: A group of device ports can be configured by specifying a comma-separated list of
ports (i.e., '1-4,8,10-12') or 'ALL'. Remove breakseq for Device Ports connected to raw
binary connections.The logging level for the Device Ports log must be set to 'Info' to view
Syslog entries for Device Port logging. It is recommended that the 'initscript' be
prepended with 'AT' and include 'E1 V1 x4 Q0' so that the SLC may properly control
the modem.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SLC 8000 Series and is the answer not in the manual?

Lantronix SLC 8000 Series Specifications

General IconGeneral
BrandLantronix
ModelSLC 8000 Series
CategorySwitch
LanguageEnglish

Related product manuals