Preface and general information
DeviceNet and CANopen
1-2
L
BA2175 EN 2.0
1.2.1 Legal regulations
Labelling
Nameplate CE -identification Manufacturer
Lenze 2175 fieldbus modules are
unambiguously identified by their nameplates.
Conforms to the EC Low-Voltage Directive Lenze GmbH & Co KG
Postfach 101352
D-31763 Hameln
Application as
directed
2175 fieldbus module
• Operate the fieldbus module only under the conditions prescribed in these Operating Instructions.
• The fieldbus module is an accessory module and can be optionally attached to the following Lenze controllers: 820X, 821X, 822X, 8200
vector, 9300 servo 9300 ser vo PLC. The 2175 fieldbus module links Lenze controllers with the fast serial communication system CAN.
• The fieldbus module must be attached and electrically connected so that it complies with its function and does not cause any hazards when
attached and operated as instructed.
• Observe all notes given in chapter „Safety Instructions“ (^ 2-1) ).
• Please observe all information given in these Operating Instructions. This means:
– Read these Operating Instructions carefully before you start to work with the system.
– These Operating Instructions must always be available during operation of the fieldbus module.
Any other use shall be deemed inappropriate!
Liability • The information, data, and notes in these Instructions met the state of the art at the time of printing. Claims referring to drive systems
which have already been supplied cannot be derived from information, illustrations, and descriptions given in these Operating Instructions.
• The specifications, processes, and circuitry described in these Instructions are for guidance only and must be adapted to your own specific
application. Lenze does not take responsibility for the suitability of the process and circuit proposals.
• The indications given in these Operating Instructions describe the features of the product without warranting them.
• Lenze does not accept any liability for damage and operating interference caused by:
– disregarding these Instructions
– unauthorized modifications to the controller
– operating faults
– improper working on and with the controller
Warranty • Warranty conditions: see Sales and Delivery Conditions of Lenze GmbH & Co KG.
• Warranty claims must be made to Lenze immediately after detecting the deficiency or fault.
• The warranty is void in all cases where liability claims cannot be made.
Disposal
Material recycle dispose
Metal D -
Plastic D -
Assembled PCBs - D
Short Instructions/Operating Instructions D
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com
To Next Page
Loading...
Need help?
General