D9U001MCX-0101_03
156
CAUTION!
Right Protector and left Protector are not interchangeable! Ensure the both Protectors are properly installed
on the bed!
19.18 Protectors
WARNING!
Risk of injury due to the patient falling o the bed!
► Ensure that the Protector is installed securely.
► Always check that the siderails are properly locked in the „up“ position.
► Make sure the fall risk assessment was done properly before Protector use.
Fig. Placement of Protector
Placement
Attach the Protector to the bed as follows:
► Insert the Protector pin into the casing in the protective ring at the corner of the foot end of the bed.
► Ensure that the xing element is secured to the telescopic prole of the bed extension.
Remove the Protector from the bed as follows:
► Grasp the upper end of the Protector.
► Remove the Protector from the casing.
The Protector is an optional accessory for the Multicare X bed. The main purpose of the Protector is to reduce the risk of fall espe-
cially at very risky patients (confused restless patients). The Protector can be used with extended or standard beds.
To Next Page
Loading...
Need help?
General
