Technical Information
122
G 1xxx/G 2xxx
Figure 050-34: Filling the Salt Container in the Door
4.35 Water Level Check
1. Fully open the water supply.
2. Start the Rinse & Hold program, then wait about 3 minutes.
3. Do not cancel the program. Slowly open the door to observe the water
level in the bottom of the wash cavity.
4. If the water level is within close proximity of the filter handle (about 4
millimeters above the filter), then sufficient water has been taken in; see
Figure 050-35.
Figure 050-35: Water Level Reference
Warning!
Inadvertently filling the salt container with dishwashing detergent will
damage the water softener.
Warning!
Only use water softener salt specially formulated for dishwashers. Other
salts may contain insoluble additives which can impair the water softener.
To Next Page
Loading...
Need help?
General
