Technical Information
134
G 1xxx/G 2xxx
2.10 Programming of Language and Time of Day at First
Commissioning (Excella/LaPerla)
At first commissioning or after replacing the electronic, a welcome message
will appear in the display. Subsequently, the language, time format and time
of day must be set as described in the operating instructions. These settings
are first saved after a complete program sequence.
3 Fault Repair
3.1 Main Switch Is On, No Message in Display
Cause:
No supply voltage.
Remedy:
1. Check electrical connection (120VAC) to appliance. If hardwired, check
for voltage at terminal block X3/1.
2. If no voltage is present at appliance, check on-site fuse/GFI. If hardwired,
check for proper connection at terminal block X3/1.
3. Check for power to electronic. If no power is present, check wire
continuity between electronic and terminal block X3/1.
4. Check for power to main switch (pushbutton switch S2). If switch is
inoperative, replace it. (In machines where the switch is part of the
electronic, replace the electronic.)
5. Check for power to door contact switch S24. If the door contact switch
has power, replace the electronic. See Section 100-4.5 or 100-4.6.
3.2 Rinse Aid Used Up Too Quickly (Models with SensorDry)
Symptom:
The customer complains that he has to replenish rinse aid relatively soon
after the last fill-up.
Cause:
Load amount or arrangement of dishes in the machine.
With the SensorDry function, an optimal drying result is consistently
achieved through specific matching of individual parameters (such as rinse
aid dispensing of up to 6 milliliters per wash). Additional information can be
found in the function description; see Section 080-2.6.
Remedy:
Brief explanation of the benefits that the customer can enjoy with SensorDry.
3.3 Program Can Be Selected but Not Started
Symptom:
After switch-on, display is normal and LEDs light up/flash as usual. However,
a program cannot be started after selection.
To Next Page
Loading...
Need help?
General
