Programming
140
Programme block
Stage Basic setting
Block name 20 blank spaces
1. Block activation No
2. Programme stop 1 No
3. Programme stop signal 1 No
4. Heating No
5. Free temperature selection No
6. Temperature Cold
7. Hysteresis Normal
8. Warm up *
9. Level 1 0mm / 0l / 1:0kg/l
10. Water inlet 1 Automatic
11. Dispensing method No
12. Dispensing phase 1 *
13. Dispensing stop 1 *
14. Agitation from level Automatic
15. Level stop 1 No
16. Wash time 1 No
17. Thermostop *
18. Level 2 0 mm
19. Water inlet 2 Automatic
20. Dispensing phase 2 *
21. Dispensing stop 2 *
22. Level stop 2 No
23. Wash time 2 No
24. Cool Down No
25. Wash time 3 No
26. Programme stop 2 No
27. Programme stop signal 2 No
28. Drain path 1 No
29. Drain level 0 mm
30. Wash time 4 No
31. Drain path 2 Drain
32. Free spin speed selection No
33. Spin No
34. Repeat No
35. Block end signal No
* "Locked" appears if "No" is programmed for Dispensing method in the relevant
programme in the Dispensing menu option.
To Next Page
Loading...
Need help?
General
