Programming
148
21. Dispensing
stop 2
Settings as for Dispensing stop 1
22. Level stop 2
Settings as for Level stop 1
23. Wash time 2
Settings as for Wash time 1
24. Cool Down
Cooling the water to a defined temperature before drainage.
Choose from the following options:
– No
Water cooling does not take place.
– Automatic
A gradual water intake takes place via the valves which have been set
in the programme step "Water inlet 2" with a cooling rate of 3°C/min.
until the max. level of the machine is reached. Subsequent to this
water will be drained until the wash level is reached. Then a gradual
water intake etc. starts again until the water temperature reaches
45°C. If the programmed target level is similar to the maximum level
of the machine, it will be reduced by 30%.
– User defined
Cooling temperature from 20 to 95°C
Cooling speed from 1 to 20°C/min.
25. Wash time 3
Settings as for Wash time 1
26. Programme
stop 2
Settings as for Programme stop 1
27. Programme
stop signal 2
Settings as for Programme stop signal 1
28. Drain path 1
The point at which the water should leave the machine, and where it
should drain to is set.
Choose from the following options:
– No
No drainage takes place. During the spin cycle, the drain valve is
opened at speeds >70rpm.
– Drain
The drain valve is activated.
– Reservoir
The drained water is transferred to the water recycling system.
– Empty reservoir
The WRG tank is emptied.
– Clean
The water is circulated.
To Next Page
Loading...
Need help?
General
