Programming
172
During data transfer the following appears in the display:
Dispensing
Data to control unit
Useful tip: If not all dispensing data was able to be copied from the
card to the controls, the following message will appear:
DispensingData to control unit
Insufficient memory
Useful tip: If copying is not possible as described above, the
following appears in the display for 5minutes:
DispensingData to control unit
Data transfer not possible
Programme
With this menu option one or more programmes can be copied from
the card to the controls.
Useful tip: Existing programmes in the controls will be overwritten.
Select the "Programme" menu option.
After selection, the following appears in the display:
Data to control unit
:
Programme
13:40 10.05.15Programme
Press the multifunction selector to confirm your selection.
The following will appear in the display:
1 Cottons hygiene 90
2 Cottons universal 60
Data to control unit
Programme
1-999
°C
°C
Option:
– All programmes are available on the card
Select or deselect programmes by pressing the multifunction
selector.
To Next Page
Loading...
Need help?
General
