01-37
01
[Supply]
• Supply fluid into power steering oil tank 1 up to filler cap 2.
• With the engine stopped, jack up the front wheels and turn the steer-
ing wheel fully left and right repeatedly. When the fluid level has
dropped, add fluid to maintain the fluid level within range A.
• Start the engine and letting it idle, turn the steering wheel fully left and
right repeatedly. When the fluid level has dropped, add fluid to main-
tain the fluid level within range A. Repeat these steps until the fluid
level does not drop.
• Depress the brake pedal fully several times repeatedly, until as in the
case of the steering wheel, the fluid level does not drop anymore. (The
steering wheel at such time does not need to be operated)
• If there is an abnormal noise, air is still in the system. Turn the steering
wheel several times, next depress the brake pedal several times to
raise the fluid temperature to approximately 60 to 80°C {140 to 176°F},
then stop the engine and wait for approximately five minutes.
• Lower the front wheels and turn the steering wheel several times to
make sure there is no abnormal noise.
• With the engine stopped, depress the brake pedal several times,
activate the brake booster (hydraulic booster) emergency pump and
bleed air.
• When there is no abnormal noise after the above procedure has been
performed, bleeding is completed. Check oil tank 1 fluid level, and
pipe and hose connections for fluid leakage.
• After bleeding is completed, inspect brake booster (hydraulic booster)
performance (input and output characteristics). ^ Gr 35
01340
2
1
A
To Next Page
Loading...
Need help?
General
