Mitsubishi FX3U Series Operation Manual

3 Window configuration and basic operation
3.3 Tool menus and tool button list
27
FX Configurator-FP
Operation Manual
1
Introduction
2
Install Uninstall Start&Exit
3
Window and Operation Config
4
Creating Files
5
Data set
6
Setting The Connection
7
Data flow And Procedure
8
Debug In the Positioning
9
Print
10
Edit Function In data
3.3 Tool menus and tool button list
The tool bar has the menus below.
Click the toolbar to show (checked)/hide (unchecked).
Tool button list
Tool bar
menu
Tool
button
Name Description
Tool bar
New Creates a new file
Open Opens an existing file
Save Saves the file being edited
Cut Cuts
Copy Copies
Paste Pastes
Print Prints
Online tool bar
Read from module Reads from the module
Write to module Writes to the module
Verify module data Verifies the module data
Monitor On/Off switch Switches the table information window into monitor mode/edit mode
Test tool bar
Test On/Off switch Switches into test mode
All axis stop Stops all axis
Error reset X-axis Resets errors at X-axis
Error reset Y-axis Resets errors at Y-axis
m code off X-axis Turns off the m code at X-axis
m code off Y-axis Turns off the m code at Y-axis
Operation test X-axis Test-operates X-axis
Operation test Y-axis Test-operates Y-axis
System reset Execute system reset
Shows the file data list
Shows the tool bar
Shows the online tool bar
Shows the test tool bar
Shows the status bar

Mitsubishi FX3U Series Specifications

General

Brand	Mitsubishi
Model	FX3U Series
Category	Controller
Language	English