Mitsubishi FX3U Series Operation Manual

63
FX Configurator-FP
Operation Manual
1
Introduction
2
Install Uninstall Start&Exit
3
Window and Operation Config
4
Creating Files
5
Data set
6
Setting The Connection
7
Data flow And Procedure
8
Debug In the Positioning
9
Print
10
Edit Function In data
7 Read / Write / Verify / Initialize
7.8 The displayed messages and countermeasures
7.8 The displayed messages and countermeasures
This section explains the countermeasures for error messages.
Displayed Message Description
Cannot communicate with the PLC. Execute again after
checking the connections with the PLC.
<ES: Error code>
A communication error has occurred.
Check the connection with PLC, and the communication
settings at the destination.
The connected PLC dose not support this function.
Please execute again after confirming the version of the
PLC.
The connected PLC is not supported.
Confirm the version of the PLC.
The module which supported this function is not found.
Please execute again after confirming the module.
The special function block with assigned module No. is
not 20SSC-H.
Confirm the module No. and the connection between PLC
and 20SSC-H.
It is range over.
Check that the value is correct, and execute again.
It is range over.
Because data disagreement has exceeded 100 items, the
verify processing is interrupted.
The disagreement in verification has exceeded 100.

Mitsubishi FX3U Series Specifications

General

Brand	Mitsubishi
Model	FX3U Series
Category	Controller
Language	English