Mitsubishi FX3U Series Operation Manual

8 Debug in the positioning
8.2 Testing the Operation
86
FX Configurator-FP
Operation Manual
8.2.10 Servo ON/OFF
Executing servo ON/OFF while test mode.
By servo ON/OFF, the servo motor turns into the state in the following table.
For the procedure to switch into test mode, refer to Subsection 8.2.1.
The execution conditions for servo ON/OFF
Servo ON/OFF is executable when the execution conditions in the following table are fulfilled.
1 Follow any of the procedures below depending on the content to be
executed.
• When executing all axis servo ON/OFF
Select [Online]  [Test]  [All axis Servo On/Off].
• When executing servo ON/OFF along the specified axis
Select [Online]  [Test]  [Tool]  [X-axis Servo On/Off command] / [X-axis Servo On/Off command]
Note
3 mark appears on the left of the menu items while the servo is ON.
The servo motor state
Servo ON Locks servo motors and turns them into the standby state
Servo OFF Unlocks servo motors, and also turns OFF the servo motor electromagnetic brake
Menu Operation Execution conditions
All axis Servo ON/OFF
Servo ON all axis • All axis (X and Y-axis) are executable for servo ON
Servo OFF all axis • X or Y-axis are executable for servo OFF
X-axis servo ON/OFF
command
Servo ON X-axis
• X-axis status information in 20SSC-H is READY
• X-axis servo status is READY ON and servo OFF
Servo OFF X-axis
• X-axis status information in 20SSC-H is READY
• X-axis servo status is servo ON
Y-axis servo ON/OFF
command
Servo ON Y-axis
• Y-axis status information in 20SSC-H is READY
• Y-axis servo status is READY ON and servo OFF
Servo OFF Y-axis
• Y-axis status information in 20SSC-H is READY
• Y-axis servo status is servo ON

Mitsubishi FX3U Series Specifications

General

Brand	Mitsubishi
Model	FX3U Series
Category	Controller
Language	English