58
FX Configurator-FP
Operation Manual
7.3 Writing [positioning/servo parameters and table information]
7 Read / Write / Verify / Initialize
7.3.2 Writing to the Flash ROM
Storing [positioning parameters, servo parameters and table information written beforehand in the 20SSC-H
BFM] in the Flash ROM. After setting up and adjusting the system, it is handy when storing [positioning
parameters, servo parameters and table information] in the BFM.
1 Select [Online] [Flash ROM write].
[Flash ROM write (BFM -> Flash ROM)] appears.
2 Select the data to be stored in the Flash ROM.
3 Click <OK>.
FX Configurator-FP stores the selected 20SSC-H BFM data in the Flash ROM.
Caution
While data on the X- or Y-axis cannot be written, data on both the X- and Y-axes cannot be written to the flash
ROM.
Wait until data on both the X- and Y-axes can be written, and then write data to the flash ROM.
Item Description
COM port Displays [COM port] in [Connection setup] dialog box
Transmission speed Displays [Transmission speed] in [Connection setup] dialog box
Module No. Displays [Module No.] in [Connection setup] dialog box
Item Ticks off the data to be stored
Positioning parameters
Ticks off the axis of positioning parameters to be stored
•X-axis
•Y-axis
Servo parameters
Ticks off the axis of servo parameters to be stored
•X-axis
•Y-axis
Table information
Ticks off the axis of table information to be stored
•X-axis
•Y-axis
•XY-axis
<OK> Store the selected data in the BFM
<Cancel> Cancels selecting and closes the dialog box
To Next Page
Loading...
Need help?
General
