Mitsubishi FX3U Series Operation Manual

4 Creating files
4.3 File storage
35
FX Configurator-FP
Operation Manual
1
Introduction
2
Install Uninstall Start&Exit
3
Window and Operation Config
4
Creating Files
5
Data set
6
Setting The Connection
7
Data flow And Procedure
8
Debug In the Positioning
9
Print
10
Edit Function In data
4.3 File storage
Storable information
• Versions of files
• Module type
• Positioning parameters
• Servo parameters
• Table information
• Connection Destination
Messages
4.3.1 Saving files
Saving stored files after editing.
1 Follow any of the procedures below to save as files.
• Click (Save).
• Select  [File]  [Save].
The currently opened file is saved.
When using a floppy disk (FD).
When saving a file in a floppy disk, Floppy disk itself needs the same amount of another free space with the
file to be saved, so floppy disk sometimes does not save the file due to the out of disk space.
When the file cannot be saved in floppy disk, save the file once in the hard drive of PC, and copy the file to
floppy disk.
Messages Conditions
The allowable No. of characters has been
exceeded. Set to less than 150 characters
The total amount of the character in the file path and
name exceeded 150 characters
Failed to save data to the file in selected drive.
The following causes are thought.
• The error occurred while saving project.
• The target Memory is low.
• The medium of selected drive is incorrect.
Could not save the file.
The following causes are thought
• The specified file does not exist
• The data in the file is completely damaged
• The data is created by other S/W

Mitsubishi FX3U Series Specifications

General

Brand	Mitsubishi
Model	FX3U Series
Category	Controller
Language	English