54
FX Configurator-FP
Operation Manual
7.1 Data type and storage location
7 Read / Write / Verify / Initialize
2. Data flow
No. Description
c
Read/Write/Monitor/Test the sequence programs with GX Developer.
d
Read out the following data from the 20SSC-H BFM to FX Configurator-FP.
• Positioning parameters
• Servo parameters
• Table information
• Monitor data (Operation status, motion status and input signal status, etc.)
e
Write the following data from FX Configurator-FP to the 20SSC-H BFM.
• Positioning parameters
• Servo parameters
• Table information
• Control data (The present value change, speed change and operation test command, etc.)
f
Read/Write the following data in BFM with sequence program.
• Positioning parameters
• Servo parameters
• Table information
• Monitor data (Operation status, motion status and input signal status, etc.)
• Control data (The present value change, speed change and operation test command, etc.)
g
Store the following BFM data to the Flash ROM by the store command from the sequence
program or FX Configurator-FP.
• Positioning parameters
• Servo parameters
• Table information
h
Positioning/servo parameters and table information transfer from the Flash ROM to the BFM in
20SSC-H at power ON, simultaneously servo parameters transfer to servo amps.
i
Servo parameters transfer to servo amps at power ON.
For transfer procedure, refer to the next page.
j
20SSC-H retrieves servo parameters changed at servo amp sides, and updates the servo
parameters in its BFM.
FX Configurator-FP: Setting/Monitoring tool for 20SSC-H
GX Developer : Programming software for PLC
FX
3U
/FX
3UC
PLC
Sequence
program
FX
3U
-20SSC-H
Flash ROM
- Positioning parameters
- Servo parameters
- Table information
Buffer Memory (BFM)
- Monitor data
- Control data
- Positioning parameters
- Servo parameters
- Table information
1 2 3
4
5 6
7
8
- Servo parameters
Servo amplifier
- Servo parameters
Servo amplifier
To Next Page
Loading...
Need help?
General
