Mitsubishi MT160D User Manual

Removing the clutch
The clutch housing must be detached from
the engine
to permit clutch removal. If the
engine need not be disassem bled, the recom-
mended practice
is to take down the whole
engine
unit complete with front axle, chassis and
radiator, and separate the
clutch housing from
the engine: this
method results in time and labor
saving.
(1) Unhook bonnet, and open bonnet. (To
facilitate work, remove the bonnet.)
(2) Disconnect negative cord and positive cord
from
battery terminals in that order.
Negative cord
Positive cord
(3) Remove side covers, right and left.
[NOTE]
Remove the muffler as necessary.
CLUTCH SYSTEM
(4) Disconnect cords from respective terminals.
Engine on-off
solenoid switch
Thermo switch
(5) Turn off fuel filter cock, and disconnect
and remove piping between fuel filter and
injection pump.
(6) Pull
out snap pin on link pin by which
governor lever
is connected to engine con-
trol rod, and remove
the control rod.
3-5

Mitsubishi MT160D Specifications

General

Brand	Mitsubishi
Model	MT160D
Category	Tractor
Language	English