7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 153
4.8 Initial System Startup Process Flow
Figure 10 shows the process to start your system. This example assumes that the
boot loader and BOF image and configuration files are successfully located.
Figure 10 System Startup Process Flow
4.9 Configuration Notes
This section describes BOF configuration guidelines.
• The loading sequence is based on the order in which the sequence is placed in
the configuration file. It is loaded as it is read during bootup.
Note: Access to a console is only disabled when the TiMOS image is loaded. Console
access remains unchanged during the boot loader stage of the boot up process. That is, the
bof command takes effect only when the node is booted with the TiMOS image.
sw0534
Start
boot.tim files found
BOF files found
Establish router connection (console port)
Configure/modify BOF file locations Primary image
Primary config
Secondary image
Secondary config
Tertiary image
Tertiary config
Power cycle router
Save config changes
To Next Page
Loading...
Need help?
General
