Nokia 7210 SAS-M User Manual

System Management
266
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
To visually determine the active and standby designations, the Status LED on the
faceplate is lit green (steady) to indicate the active designation. The Status LED on
the second CPM faceplate is lit amber to indicate the standby designation.
The following output sample shows that the CPM installed in slot A is acting as the
active CPM and the CPM installed in slot B is acting as the standby.
A:7210SASR1# show card
===============================================================================
Card Summary
===============================================================================
Slot Provisioned Type Admin Operational Comments
Equipped Type (if different) State State
-------------------------------------------------------------------------------
1 imm-sas-10sfp+1xfp up up
2 imm-sas-10sfp+1xfp up up
A cpm-sf-sas-R6 up up/active
B cpm-sf-sas-R6 up up/standby
===============================================================================
A:7210SASR1#
The following console message is displayed if a CPM boots, detects an active CPM,
and assumes the role of the standby CPM.
...
Slot A contains the Active CPM
This CPM (slot B) is the standby CPM.
6.4.2 Active and Standby Designations on 7210 SAS-Sx/
S 1/10GE in Standalone-VC Mode
On the 7210 SAS-Sx/S 1/10GE configured in the standalone-VC mode, the user
must designate and configure two nodes as CPM-IMM nodes. During boot up, one
of the configured nodes assumes the active CPM role and the other assumes the
standby CPM role. Typically, the configured CPMA-IMM node is favored to be the
active CPM and the CPMB-IMM is favored to be the standby CPM. If only one CPM-
IMM node is configured, it becomes the active CPM.
To visually determine the active and standby designations, the Master LED on the
faceplate is lit (steady) to indicate the active designation. The Master LED on the
standby CPM faceplate blinks to indicate the standby designation.
The following output sample shows two nodes configured as CPM-IMM nodes with
one becoming the active node and the other becoming the standby node.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English