7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Getting Started
Edition: 01 3HE 16132 AAAB TQZZA 17
1 Getting Started
This chapter provides an overview of the document organization and content, and
describes the terminology used in this guide.
1.1 About This Guide
This guide describes system concepts and provides configuration examples to
configure the boot option file (BOF) on the following 7210 SAS platforms, operating
in one of the modes described in Table 1. If multiple modes of operation apply, they
are explicitly noted in the topic.
• 7210 SAS-M
• 7210 SAS-Mxp
• 7210 SAS-R6
• 7210 SAS-R12
• 7210 SAS-Sx/S 1/10GE
• 7210 SAS-Sx 10/100GE
• 7210 SAS-T
See section 1.2 for information about the modes of operation supported by the
7210 SAS product family.
Note: Unless explicitly noted otherwise, the phrase “Supported on all 7210 SAS platforms
as described in this document” is used to indicate that the topic and CLI commands apply
to all the 7210 SAS platforms in the following list, when operating in the specified modes
only.
• network mode of operation
7210 SAS-M, 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, and 7210 SAS-T
• standalone mode of operation
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE
• standalone-VC mode of operation
7210 SAS-Sx/S 1/10GE
If the topic and CLI commands are supported on the 7210 SAS-M and 7210 SAS-T
platforms operating in the access-uplink mode, it is explicitly indicated, where applicable.
To Next Page
Loading...
Need help?
General
