Parts
7-1
Part 1024496_06
2014 Nordson Corporation
Section 7
Parts
NOTE: Refer to Appendix E for information about 400/480 Volt melter parts.
Using the Illustrated Parts List
The parts lists provided in this section are organized into the following
columns:
Item—Identifies illustrated parts that are available from Nordson
Corporation.
Used—Identifies the melters in which the part is used. A blank entry
indicates that the part is used in all ProBlue melters.
Part—Provides the Nordson Corporation part number for each saleable
part shown in the illustration. A series of dashes in the parts column
(‐ ‐ ‐ ‐ ‐ ‐) means the part cannot be ordered separately.
Description—Provides the part name, as well as its dimensions and
other characteristics when appropriate. Bullets in the description, indicate
the relationships between assemblies, subassemblies, and parts.
Quantity—The quantity required per unit, assembly, or subassembly.
The code AR (As Required) is used if the part number is a bulk item
ordered in quantities or if the quantity per assembly depends on the
product version or model.
NOTE: Illustrations of the model P4 are used throughout this section to
represent all ProBlue melters. Refer to the Used column to determine the
part number associated with your melter.
Fasteners
Fasteners are called out in each illustration using the convention Fx, where
“x” is the fastener number used in the Schedule of Fasteners, which is
located at the end of this section.
To Next Page
Loading...
Need help?
General
