Operation
4-1
Part 1024496_06
2014 Nordson Corporation
Section 4
Operation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
This section provides information about the following operator‐level tasks:
Filling the melter tank
Starting the melter
Monitoring melter operation
Adjusting the operating temperature of heated components
Using the melter function keys
Shutting the melter down
Most of the controls described in this section are located on the control panel
behind the keypad door. Refer to Section 2, Key Components, for
the location of the control panel.
Additional Information
This section presents operating procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information table that follows most procedures. Where applicable,
some table entries also contain cross‐reference information. Additional
information tables are indicated by the symbol shown to the left.
To Next Page
Loading...
Need help?
General
