OkiLAN 8200e Network User’s Guide
211
Troubleshooting:
Novell NetWare
Printer cannot find the network print server.
• Turn the printer off and on again.
• Confirm that the network interface is enabled on the printer.
• Make sure the network cable is correctly connected.
• Change the cable and try again.
• If the NetWare protocol is disabled, set it to Enable.
• Reset the network interface card to factory default settings.
The network print server is identified by the setup
utility but not by the NetWare server.
• Start up the NetWare server and check the NIC configuration.
• Make sure the NSAP packet on the NetWare server is not set to Disable.
• Make sure the correct print server is operating on the file server.
• Make sure the Print Server name operating on the File Server and the
Print Server name set in the NIC are the same.
• Make sure the Printer name displayed in the Print Server monitor of the
File Server and the NetWare Port name set in the NIC are the same. If
there are multiple network interface cards, configure the NetWare Port
names to be different.
Problems with Print Server mode
• Make sure the File Server name set in the NIC and on the File Server are
the same.
• Make sure the Printer name set in the File Server and the NetWare Port
name set in the NIC are the same. If there are multiple NICs, configure
the NetWare Port names to be different.
• Make sure the NetWare login password is correct.
Important!
The network addresses used in this manual are shown for
example only. Network addresses used in your installation
must be generated from your own network.
To Next Page
Loading...
Need help?
General
