Oki C9600n Network And Configuration Guide

OkiLAN 8200e Network User’s Guide
213
Troubleshooting:
EtherTalk
Not identified by the Chooser and the Setup Utility.
• Turn the printer off and on again.
• Make sure the network cable is correctly connected.
• Change the cable and try again.
• If the network resides in a Zone, make sure the correct Zone name is
selected in the Chooser.
• Make sure the Zone name in the utility related to the NIC is the same as
the Zone name set in NIC.
• Make sure AppleTalk, which is displayed at the right bottom of the
Chooser, is set to Enable. (In some OS versions Network is used instead
of AppleTalk.)
• Make sure Ethernet is selected in AppleTalk. (In some OS versions
Network is used instead of AppleTalk.)
• Make sure the print driver is selected in the Chooser.
• Make sure the EtherTalk protocol is set to Enable.
• Print the NIC settings (see page 12) and confirm that the EtherTalk Port
name is not blank.

Oki C9600n Specifications

General

Brand	Oki
Model	C9600n
Category	Printer
Language	English