To Next Page

To Previous Page

9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service

Manual

6.5

SHIFT CABLE ADJUSTMENT

1. Locate the shift cable attached to the transmission

case in the right rear wheel well area.

2. Inspect shift cable

, clevis pin, pivot bushings, and

dust boot

. Replace if worn or damaged.

3. If adjustment is required, loosen the lower jam nut

and pull the cable out of the mount

to move the

upper jam nut

4. Adjust the shift cable so there is the same amount of

cable travel when shifting slightly past HIGH gear and

PARK.

5. Thread the upper or lower jam nut as required to

obtain proper cable adjustment.

NOTE

This procedure may require a few attempts to obtain

the proper adjustment.

6. Once the proper adjustment is obtained, place the

shift cable and upper jam nut into the mount. Tighten

the lower jam nut against the mount.

7. Start engine and shift through all gears to ensure the

shift cable is properly adjusted. If transmission still

ratchets after cable adjustment, the transmission will

require service.

TRANSMISSION

Polaris RZR 900 2016 Service Manual

Questions and Answers: