EasyManuals Logo
Home>Polaris>Offroad Vehicle>RZR 900 2016

Polaris RZR 900 2016 Service Manual

Polaris RZR 900 2016
543 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #493 background imageLoading...
Page #493 background image
11
9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.
11.3
GENERAL INFORMATION
TORQUE SPECIFICATIONS
COMPONENT TORQUE
Battery Hold-Down Bracket 8 ft-lb (11 Nm)
Battery Terminal Fasteners 60 in-lb (7 Nm)
Brake Switch
15 ft-lb (20
Nm)
Ignition Coil Mounting Fasteners 75 in-lb (9 Nm)
Starter Mounting Fasteners 7 ft-lb (10 Nm)
SPECIAL TOOLS
PART NUMBER
TOOL DESCRIPTION
PV-43568
Fluke™ 77 Digital Multimeter
PV-43526 Connector Test Kit
2870630
Timing Light
PU-50338
Battery Hydrometer
2460761 Hall Effect Sensor Probe Harness
2871745
Static Timing Light Harness
PU-50296
Battery Conductance Analyzer
(MDX-610P)
PU-49466
Relay Bypass
Bosch Automotive Service Solutions:
1-800-345-2233 or http://polaris.service-solutions.com/
SERVICE NOTES
Keep the following notes in mind when diagnosing an
electrical problem:
Refer to wiring diagram for stator and electrical
component resistance specifications.
When measuring resistance of a component that has a
resistance value under 10 Ohms, remember to
subtract meter lead resistance from the reading.
Connect the leads together and record the resistance.
The resistance of the component is equal to tested
value minus the lead resistance.
Become familiar with the operation of your meter. Be
sure leads are in the proper jack for the test being
performed (i.e. 10A jack for current readings). Refer to
the Owner’s Manual included with your meter for more
information.
Voltage, amperage, and resistance values included in
this manual are obtained with a Fluke™ 77 Digital
Multimeter (PV-43568). This meter is used when
diagnosing electrical problems. Readings obtained
with other meters may differ.
Pay attention to the prefix on the multimeter reading
(K, M, etc.) and the position of the decimal point.
For resistance readings, isolate the component to be
tested. Disconnect it from the wiring harness or power
supply.
The headlights, taillights, switches and LED light will
stay on for approximately 20 seconds after the key has
been switched OFF. This is a normal occurrence.
UNDER DASH COMPONENTS
The following switches and components can be
accessed underneath the instrument / dash panel:
Speedometer
AWD Switch
Headlamp Switch
12 Vdc Accessory Power Point
Ignition Switch
LED Ambiance Light
ELECTRICAL

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris RZR 900 2016 and is the answer not in the manual?

Polaris RZR 900 2016 Specifications

General IconGeneral
BrandPolaris
ModelRZR 900 2016
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals