11
9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.
11.13
AWD/2WD/TURF SWITCH (MODELS WITH
TURF)
1. Disconnect the AWD/2WD/Turf switch harness by
depressing the connector locks and pulling on the
connector. Do not pull on the harness.
2. Test between the three sets of outputs (AWD / 2WD /
TURF). If any of the tests fail, replace the switch.
• Move the switch to AWD. There should be continuity
between switch pins 2 and 3; 5 and 6.
• Move the switch to 2WD. There should be no
continuity between any pins.
• Move the switch to TURF. There should be continuity
between switch pins 1 and 2; 4 and 5.
TRANSMISSION (GEAR POSITION) SWITCH
1. The transmission (gear position) switch
q
is located
on the RH side of the transmission and can be
accessed through the RH wheel well area.
2. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
ELECTRICAL
To Next Page
Loading...
Need help?
General
