To Next Page

To Previous Page

9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service

Manual

7.7

REAR CARRIER BEARING REPLACEMENT

1. Remove the outer snap ring

2. From the back side of the bearing carrier, tap on the

outer bearing race with a drift punch in the reliefs as

shown.

3. Drive bearing out evenly by tapping on outer race

only. Once bearing is at bottom of casting, support

casting on outer edges so bearing can be removed.

4. Inspect the bearing carrier housing for scratches,

wear or damage. Replace rear bearing carrier if

damaged.

5. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

6. Support the bottom of the bearing carrier housing.

CAUTION

Use an arbor and press only on the outer race or

bearing damage may occur.

7. Apply Loctite® 603™ retaining compound to the

outer circumference of the new bearing race

and

carefully press the new bearing into the bearing

carrier housing

NOTE

Use care to not allow any of the Loctite® compound to

get in the bearing.

8. Wipe the housing clean of any excess compound and

install the snap ring

FINAL DRIVE

Polaris RZR 900 2016 Service Manual

Questions and Answers: