EasyManuals Logo
Home>Polaris>Offroad Vehicle>RZR 900 2016

Polaris RZR 900 2016 Service Manual

Polaris RZR 900 2016
543 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
2.28
9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.
STEERING SYSTEM
STEERING INSPECTION
The steering components should be checked periodically
for loose fasteners, worn tie rod ends, ball joints and
damage. Also check to make sure all cotter pins are in
place. If cotter pins are removed, they must be replaced.
Replace any worn or damaged steering components.
Steering should move freely through the entire range of
travel without binding. Check routing of all cables, hoses,
and wiring to be sure the steering mechanism is not
restricted or limited.
NOTE
Check front end alignment whenever steering
components are replaced.
WARNING
Due to the critical nature of the procedures outlined in
this chapter, Polaris recommends steering component
repair and adjustment be performed by an authorized
Polaris MSD certified technician.
STEERING WHEEL FREE-PLAY
Check steering wheel for specified free-play and
operation.
1. Position the vehicle on level ground.
2. Lightly turn the steering wheel left and right.
3. There should be 0.8-1.0″ (20-25 mm) of free-play.
4. If there is excessive free-play or the steering feels
rough, inspect the following components.
Tie Rod Ends
q
Steering Shaft U-Joints
w
Steering Rack
e
TIE ROD END / WHEEL BEARING
INSPECTION
To check for play in the tie rod end, grasp the steering
tie rod, pull in all directions feeling for movement.
Replace any worn steering components. Steering
should move freely through entire range of travel
without binding.
Elevate front end of machine so front wheels are off
the ground. Check for any looseness in front wheel/
hub assembly by grasping the tire firmly at top and
bottom first, and then at front and rear. Try to move the
wheel and hub by pushing inward and pulling outward.
If abnormal movement is detected, inspect the hub and
wheel assembly to determine the cause (loose wheel
nuts or loose front hub nut).
Refer to Chapter 7 “Final Drive” for front hub service
procedures.
MAINTENANCE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris RZR 900 2016 and is the answer not in the manual?

Polaris RZR 900 2016 Specifications

General IconGeneral
BrandPolaris
ModelRZR 900 2016
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals