Rigol DS4024 User Manual

RIGOL Chapter 10 Pass/Fail Test
10-8 MSO4000/DS4000 User’s Guide
[Trig Out/Calibration] connector at the rear panel each time a failed
waveform is detected if AuxOutput is set to “ON”.
2. Turn the alarm on or off
Press Output to select “Fail” or “Fail+ ”.
 Fail: when failed waveforms are detected, the beeper does not sound.
 Fail+
: when failed waveforms are detected, the beeper sounds (not
related to the on/off state of the oscilloscope sound (refer to “Sound”).
3. Turn the output of the [Trig Out/Calibration] connector at the rear
panel on or off
Press AuxOutput to select “ON” or “OFF”.
 ON: the oscilloscope will output a TTL high level when failed waveforms are
detected until the current frame of waveform finishes and output a low level
from the start of the next frame of waveform.
 OFF: the output of the [Trig Out/Calibration] connector at the rear panel
has no relation with the pass/fail test.
Note:
 You can also press Utility  AuxOutput and select “PassFail” to control
the [Trig Out/Calibration] connector at the rear panel to output the test
failure signal.
 When Utility  AuxOutput is set to “TrigOut”, “Fast” or “GND”, Utility 
Pass/Fail  AuxOutput will be set to “OFF” automatically.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30

Rigol DS4024 Specifications

General

Brand	Rigol
Model	DS4024
Category	Test Equipment
Language	English