Name: Rigol DS4024
Brand: Rigol
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 10 Pass/Fail Test RIGOL

MSO4000/DS4000 User’s Guide 10-7

To Turn the Test Result Display On/Off

Press Utility  Pass/Fail  Enable and select “ON” to enable the pass/fail test

function; then, press Message to turn on or off the display of the test result statistic

information.

The test result statistic information includes the number of failed frames (Fail), the

number of passed frames (Pass) and the total number of frames (Total). The

information (as shown in the figure below) is displayed at the upper-right side of the

screen.

To Set the Output Form of Test Failure

Press Utility  Pass/Fail to open the pass/fail test menu. In this menu, you can

set the operation that the oscilloscope will execute when failed waveform is detected

according to your need.

1. Turn the stop on fail on or off

Press StopOnFail to select “ON” or “OFF”.

 ON: when failed waveform is detected, the oscilloscope will stop the test

and enter the “STOP” state.

At this point, the test result statistic information of the last test remains the

same on the screen if Message is set to “ON”; a pulse will be output from

the [Trig Out/Calibration] connector at the rear panel if AuxOutput is

set to “ON”.

 OFF: the oscilloscope will continue the test even though failed waveforms

are detected.

At this point, the test result statistic information on the screen will update

continuously if Message is set to “ON”; a pulse will be output from the

Rigol DS4024 User Manual

Other manuals for Rigol DS4024