* This will not affect parts for which the Part Multi-Effects
Switch is "OFF."
☞
“Specifying the Part(s) to Which Multi-Effects
Will Be Applied (Part Multi-Effects Switch)” (p.
124)
Delay Level
This is the setting page for “Adjusting the Overall
Delay Volume (Delay Level)” (p. 104).
Range: 0–127
Applying Various Effects to
the Sound (Multi-Effects)
Multi Effects provides 24 different Effects Types, each
of which let you apply a different effect. In the Multi-
Effects parameters you can make settings that deter-
mine how Multi-Effects will sound.
Selecting the Type (Multi-Effects Type)
1. Press [ENVELOPE/LFO1/EFFECTS] several
times to make the EFFECTS indicator light.
2. Hold down [ENVELOPE/LFO1/EFFECTS] and
use [INC] [DEC] or the [VALUE] dial to select
the effect type.
fig.0-34-2 (#MC fig.4-23)
Available Settings:
4-BAND-EQ: 4 band EQ (modify the tone) (p. 107)
SPECTRUM: Spectrum (add character to the
sound) (p. 108)
ENHANCER: Enhancer (add sparkle to the sound)
(p. 109)
OVERDRIVE: Overdrive (distort the sound mildly)
(p. 109)
DISTORTION: Distortion (distort the sound severe-
ly) (p. 110)
Lo-Fi: Lo-Fi (simulate a “low-fidelity”
sound) (p. 110)
NOISE: Noise generator (add various types
of noise) (p. 111)
RADIO-TUNG: Radio tuning (simulate a radio being
tuned) (p. 112)
PHONOGRAPH
: Phonograph (simulate an old
record) (p. 112)
COMPRESSOR: Compressor (make the volume level
more consistent) (p. 113)
LIMITER: Limiter (smooth out irregularities in
volume) (p. 113)
SLICER: Slicer (apply successive cuts to the
sound) (p. 114)
TREMOLO: Tremolo (cyclic changes in volume)
(p. 115)
PHASER: Phaser (modulate the sound) (p. 115)
CHORUS: Chorus (add spaciousness and
depth to the sound) (p. 116)
SPACE-D: Space-D (add transparent depth) (p.
117)
TETRA-CHRS: Tetra chorus (layer chorus sounds to
a dd spaciousness) (p. 117)
FLANGER: Flanger (add metallic resonance to
the sound) (p. 118)
ST-FLANGER: Step flanger (add metallic resonance
to the sound while changing the
pitch in steps) (p. 119)
SHORT-DELY: Short delay (add echoes to the
sound) (p. 120)
AUTO-PAN: Auto pan (automatically move the
stereo location) (p. 121)
FB-P-SHIFT: Feedback pitch shifter (skew the
pitch) (p. 122)
REVERB: Reverb (add reverberation) (p. 123)
GATE-REVRB: Gated reverb (sharply cut the rever-
beration) (p. 123)
Adjusting the Overall Multi-
Effects Volume
(Multi-Effects Output Level)
This adjusts the volume of the multi-effects for all
eight parts (parts 1–7 and the rhythm part).
1. Press [ENVELOPE/LFO1/EFFECTS] several
times to make the EFFECTS indicator light.
2. Rotate the [MULTI CTRL 3] knob to adjust
the Multi Effects level.
fig.7-16
Range: 0–127
To Next Page
Loading...
Need help?
General
