Patch Initialize
This operation initializes a patch.
1. Press [PATCH] to access the patch select
page.
2. Select the patch that you wish to initialize.
3. Press [UTILITY].
The indicator will light.
4. Press PAGE [<] [>] several times to select
“INITIALIZE,” and press [ENTER].
5. Select “PATCH,” and press [ENTER].
The following display will appear.
fig.5-91
If you decide to cancel the operation, press [EXIT].
6. Press [ENTER].
fig.0-005
The Patch Initialize operation will be carried out, then
the normal display will reappear.
Chapter 5. Creating Original Sounds (Patch Edit)
84
5
To Next Page
Need help?
General
