If you would like to know the control number
assignments for each knob in MODE1 and
MODE2...
☞ “Transmit/Receive Setting List” (p. 235)
*
* If you want the JX-305 to receive MIDI messages that
were transmitted from the knobs to an external device
(and then re-transmitted back to the JX-305), you must
select the same Edit Transmit/Receive Mode with which
the data was originally transmitted. If this setting is dif-
ferent, MIDI messages will not be received correctly.
Reception Settings for Each Type
of Message
Rx.PG (Receive Program Change Switch)
Specifies whether or not each part will receive pro-
gram changes.
Range: OFF, ON
When this is “OFF,” program changes will not be
received.
Rx.Bank Sel (Receive Bank Select Switch)
Specifies whether or not each part will receive bank
select messages.
Range: OFF, ON
When this is “OFF,” bank select messages will not be
received.
Rx.Sys-Ex (Receive System Exclusive Switch)
Specifies whether or not each part will receive system
exclusive messages.
Range: OFF, ON
When this setting is “OFF,” system exclusive messages
will not be received.
Transmission Settings for Each
Type of Message
Tx.PG (Transmit Program Change Switch)
Specifies whether or not program changes will be
transmitted from MIDI OUT when the patch of each
part is changed.
Range: OFF, ON
When this setting is “OFF,” program changes will not
be transmitted.
Tx.Bank Sel (Transmit Bank Select Switch)
Specifies whether or not bank select messages will be
transmitted from MIDI OUT when the patch of each
part is changed.
Range: OFF, ON
When this setting is “OFF,” bank select messages will
not be transmitted.
Tx.Act-Sens (Transmit Active Sensing
Switch)
Specifies whether or not Active Sensing messages will
be transmitted from MIDI OUT.
Range: OFF, ON
When this setting is “OFF,” these messages will not be
transmitted.
Sequencer-Related Settings
1. Press [EDIT].
The indicator will light and the display will show the
Edit page.
2. Press BANK [7] (SEQUENCER).
The SEQUENCER setting page will appear.
3. Use PAGE [<] [>] to select parameters, and
use [INC] [DEC] or the [VALUE] dial to set
each parameter.
fig.13-4(fig.15-4)
To exit the setting page, press [EXIT].
To Next Page
Loading...
Need help?
General
