Strength specifies the degree to which the note timing
will be corrected toward the note value specified by
Resolution. Rotating the knob clockwise will cause the
notes to be corrected all the way to their correct timing.
When this setting is at “0%,” the notes will be played
at their original (un-quantized) timing.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
In the Grid Quantize setting page, you can use PAGE
[<] [>] to access the Strength setting page and view the
numerical value of the knob setting while you apply
quantization.
fig.3-58-1
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Giving Swing to the Rhythm
(Shuffle Quantize)
By applying Shuffle Quantize, you can adjust the tim-
ing of the backbeats of the pattern to create “bouncy”
rhythms such as shuffle or swing.
fig.3-59 (=MC fig.7-8)
Specifying the Unit (Resolution)
Specifies the Resolution. The timing of notes will be
adjusted to the nearest grid interval of the note value
you specify here. Set this to the length of the smallest
note value that occurs in the pattern.
1. Press [PTN/SONG].
2. Press [GRID/SHFFLE/GROOVE] several
times to make the SHUFFLE indicator light.
fig.3-62
3. Press [EDIT].
The indicator will light and the display will show the
Edit page .
4. Press NUMBER [7] (QUANTIZE).
The Shuffle Quantize setting page will appear.
fig.3-60 (#MC =fig.7-9)
5. Use [INC] [DEC] or the [VALUE] dial to speci-
fy the Resolution.
Range:
To exit the setting page, press [EXIT].
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
When the SHUFFLE indicator is lit, you can also hold
down [GRID/SHUFFLE/GROOVE] and rotate the
[VALUE] dial to modify the Resolution.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Applying Shuffle Quantize
1. Play back the pattern that you wish to
quantize.
2. Press [GRID/SHUFFLE/GROOVE] several
times to make the SHUFFLE indicator light.
fig.3-62 (#MC fig.7-11)
3. Shuffle Quantize will be applied according
to the Resolution setting.
4. In the QUANTIZE section, rotate the [TIM-
ING] knob to adjust the Shuffle Rate.
Range: 0–100 %
fig.3-63 (#MC fig.7-12)
To Next Page
Loading...
Need help?
General
