Selecting Parts to Use with Play
Quantize
Play Quantize can be applied to the playback of a spe-
cific part. Before you apply Play Quantize, you must
specify the part(s) to which it will apply.
1. Hold down [SHIFT] and press [QTZ SELECT].
The button indicator will blink.
fig.3-52 (#MC fig.7-1)
2. Use PART [1]–[R] to select the part(s) to
which you wish to apply Play Quantize.
Play Quantize will be applied to the parts whose indi-
cators are lit.
fig.3-53 (#MC fig.7-2)
You can simultaneously select more than one part.
Correcting Inaccuracies in the
Rhythm (Grid Quantize)
Grid Quantize will quantize the pattern playback tim-
ing to the nearest specified note value. This will cause
the pattern to play back with accurate timing.
fig.3-54 (=MC fig.7-3)
* When Grid Quantize is used, the playback timing will be
correct, but conversely this may produce a mechanical,
inhuman feel. If you wish to preserve the feel of the perfor-
mance, you can set Resolution to a fine value, or lower the
Strength setting.
Specifying the Unit (Resolution)
The note value unit to which quantization will adjust
the timing is called the Resolution. The timing of notes
will be adjusted to the nearest grid interval of the note
value you specify here. Set this to the length of the
smallest note value that occurs in the pattern.
1. Press [PTN/SONG].
2. Press [GRID/SHFFLE/GROOVE] several
times to make the GRID indicator light.
fig.3-57
3. Press [EDIT].
The indicator will light and the display will show the
Edit page.
4. Press NUMBER [7] (QUANTIZE).
The Grid Quantize setting page will appear.
fig.3-55 (#MC fig.7-4)
5. Use [INC] [DEC] or the [VALUE] dial to set
the Resolution.
Range:
To exit the setting page, press [EXIT].
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
When the GRID indicator is lit, you can also hold
down [GRID/SHUFFLE/GROOVE] and rotate the
[VALUE] dial to modify the Resolution.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Applying Grid Quantize
1. Play back the pattern that you wish to
quantize.
2. Press [GRID/SHUFFLE/GROOVE] several
times to make the GRID indicator light.
fig.3-57 (#MC fig.7-6)
3. Grid Quantize will be applied to the play-
back data according to the Resolution set-
ting.
4. In the QUANTIZE section, rotate the [TIM-
ING] knob to adjust the Strength.
Range: 0–100%
fig.3-58 (#MC fig.7-7)
To Next Page
Loading...
Need help?
General
