Phase
Adjusts the spread of the sound.
Range: 0–180
As this value is increased, the left/right spread of the
sound will increase.
Step Rate [MULTI CTRL 2]
Specifies the rate at which the pitch will change.
Range: 0.05–10.0 (Hz)
If a note value is selected as the value of this parame-
ter, the Step Rate will synchronize with the tempo of
the pattern at intervals of the specified note value.
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the flanger sound.
Range: D100:0E–D0:100E
With a setting of “D100:0E” no flanger sound will be
output.
Output Level [MULTI CTRL 3]
Specifies the output volume of the Step Flanger effect.
Range: 0–127
Short Delay (Add Echoes to the Sound)
This is a short delay which allows you to set the left
and right delay times independently. You can also
move the panning of the delay sound in synchroniza-
tion with the tempo.
fig.7-47 (#MC fig.4-57)
Time L (Delay Time Left) [MULTI CTRL 1]
Specifies the time from the original sound until the left
delay sound is heard.
Range: 0.1–190
Time R (Delay Time Right) [MULTI CTRL 2]
Specifies the time from the original sound until the
right delay sound is heard.
Range: 0.1–190
HF Damp
Determines the frequency at which the high frequency
portions of the delay sound will be cut.
Range: 200–8000 (Hz), BYPASS
As this parameter is set to a lower frequency, more of
the high range will be cut, making the delay sound
more muted in tone.
If you do not wish to cut the high frequency range,
select “BYPASS.”
To Next Page
Loading...
Need help?
General
