Feedback Pitch Shifter (Skew the Pitch)
This effect shifts the pitch of the original sound and
layers it with the original sound. It can be used to play
unison lines at an interval of an octave or fifth, or to
layer a slightly pitch-shifted with the original sound to
create a chorus effect.
fig.7-51 (#MC fig.4-62)
Coarse (Coarse Pitch) [MULTI CTRL 1]
Specifies the amount of pitch shift relative to the origi-
nal sound, in semitone steps.
Range: -24–+12
Fine (Fine Pitch) [MULTI CTRL 2]
Adjusts the amount of pitch shift in 2-cent steps.
Range: -100–+100
Output Pan
Determines the stereo location of the pitch-shifted
sound.
Range: L64–63R
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
pitch-shifted sound is heard.
Range: 0.0–100
Mode (Pitch Shifter Mode)
Specifies how the pitch will be shifted.
Range: 1–5
As this setting is increased, the response will be slow-
er, but the sound will be more stable.
Feedback (Feedback Level)
Specifies the proportion of the pitch-shifted sound that
will be fed back into the input.
Range: 0–+98 (%)
Low Gain
Adjusts the boost or cut of the low frequency range.
Range: -15–+15
High Gain
Adjusts the boost or cut of the high frequency range.
Range:-15–+15
Balance (Effect Balance)
Specifies the volume balance between the original
sound and the pitch-shifted sound.
Range: D100:0E–D0:100E
When the setting is “D100:0E” the pitch-shifted sound
will not be output.
Output Level [MULTI CTRL 3]
Specifies the output volume of the Feedback Pitch
Shifter effect.
Range: 0–127
To Next Page
Loading...
Need help?
General
