EasyManuals Logo

Roland M-480 User Manual

Roland M-480
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
191
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1.
Access the M-48 LOAD/SAVE popup.
fig.ScrM48LoadSave.eps
2.
In the project file list, select the project file that you want
to load.
By selecting a folder and pressing [ENTER], you can move
downward into that folder. By selecting “..” and pressing
[ENTER] you can move back to the folder above the current
one.
3.
In the target unit list, select the M-48 unit into which you
want to load the project.
If you want to load the project into multiple M-48 units, press
[ENTER] to add or clear the appropriate check marks.
By pressing [F1 (MARK ALL)] or [F2 (CLEAR MARKS)] you can add
or clear the check marks in all MARK fields of the target unit list.
4.
Press [F5 (LOAD)].
fig.ScrM48Load_Conf.eps
A message will ask you to confirm the operation.
Loading will require approximately one minute for each unit.
The total amount of time required for loading will depend on
the number of M-48 units you selected in step 3.
Pressing [F7 (CANCEL)] will cancel the operation.
5.
Press [F8 (LOAD)]; the load operation will be executed,
and a message will indicate the processing status.
When loading is finished, the “Completed” message will
appear.
Press [F8 (OK)] to close the message.
Do not disconnect the USB memory or switch off the M-480’s
power while data is being loaded from USB memory. Doing
so may damage the data saved on USB memory.
1.
Access the M-48 LOAD/SAVE popup.
fig.ScrM48LoadSave.eps
2.
In the project file list, select the project file that you want
to delete.
This operation cannot delete files or folders other than M-48
project files or folders.
A folder must be empty before it can be deleted.
3.
Press [F7 (DELETE)].
fig.ScrDelete_Conf.eps
A message will ask you to confirm the operation.
4.
Press [F8 (DELETE)] to delete the file or folder.
Pressing [F7 (CANCEL)] will cancel the operation.
Loading an M-48 project from USB
memory
Deleting a project file or folder
M-480_e.book 191 ページ 2011年3月2日 水曜日 午前9時20分

Table of Contents

Other manuals for Roland M-480

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland M-480 and is the answer not in the manual?

Roland M-480 Specifications

General IconGeneral
BrandRoland
ModelM-480
CategoryMusic Mixer
LanguageEnglish

Related product manuals