90
Input/output patchbay
Input/output patchbay
Output patchbay operations
1.
Access the PATCHBAY screen.
2.
Press [F2 (OUTPUT)] to access the OUTPUT tab.
fig.ScrPatchOut1608.eps
3.
Press [F3 (REAC A)], [F4 (REAC B)], or [F5 (CONSOLE)] to
select the desired location for the output jack.
4.
Move the cursor to the intersection of the desired
channel and jack, and press [ENTER].
fig.ScrPatchOutChgConf.eps
If a channel is already patched to the output port, a message
will ask you to confirm the output patching change.
Press [F8 (ASSIGN)] to change the output patching.
Pressing [F7 (CANCEL)] will cancel the operation.
If the “PATCHBAY CHANGE” item in the CONFIRMATION section
of User Preference (p. 141) is unselected, no confirmation
message will appear in step 4.
The output patchbay library lets you store the current output
patchbay settings for later recall.
The OUTPUT PATCHBAY LIBRARY popup is used to perform
output patchbay library operations.
1.
Access the PATCHBAY screen.
2.
Press [F2 (OUTPUT)] to access the output patchbay.
fig.ScrPatchOut1608.eps
3.
Press [F6 (LIBRARY)] to access the OUTPUT PATCHBAY
LIBRARY popup.
fig.ScrOutPatLibGuide.eps
Library data list
This is a list of library data.
The function buttons have the following operations:
For details on library operations, refer to “Library operations” (p.
39).
Editing the output patching
If you attempt to patch to a CONSOLE OUT that an EXT FX is
using, a caution message such as the following will appear:
fig.ScrOutPatchExtFx.eps
Press [F8 (DISABLE)] to disable the corresponding EXT FX and
continue with the patching change.
Pressing [F7 (CANCEL)] will cancel the operation.
Using the output patchbay library
[F3 (NAME EDIT)] Accesses the NAME EDIT popup.
[F4 (RECALL)] Recalls the selected library data.
[F5 (STORE)] Stores the current settings into the selected
library data.
[F6 (CLEAR)] Clears the selected library data.
[F7 (LOCK)] Locks/unlocks the selected library data.
[F8 (CLOSE)] Closes the popup.
1
1
M-480_e.book 90 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
