28
Explanation of the panels
Explanation of the panels
fig.TalkbackOscSectGuide.eps
MIC LEVEL knob
This adjusts the preamp gain of the TALKBACK MIC input
over a range of -10 dBu– -50 dBu.
In the TALKBACK/OSCILLATOR screen, you can select a talkback
mic input from the CONSOLE INPUT 1–4.
[DISP] button
This button accesses the TALKBACK/OSCILLATOR screen,
where you can make talkback settings and oscillator
settings. It will light red when the screen is shown.
[TALKBACK] button
This button turns talkback on/off. It will blink while talkback
is on.
fig.MonitorSectGuide.eps
LEVEL knob
This adjusts the monitor output level in a range of -Inf dB –
+10.0 dB.
[DISP] button
This button accesses the MONITOR screen where you can
make monitor or solo settings. It will light red when the
screen is shown.
[SOLO CLEAR] button
This button clears (turns off) the solo settings of all channels
in a single operation.
fig.USBMemoryGuide.eps
You can connect USB memory to this connector.
Before you disconnect USB memory, make sure that data is
not being written to USB memory or being read from it. If
you disconnect USB memory while these operations are
occurring, you risk damaging the data.
TALKBACK/OSC (talkback/oscillator) section
15
1
2
3
1
2
3
MONITOR section
USB MEMORY connector
1
2
3
M-480_e.book 28 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
