57
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
Most operations for the AUX, MTX, and MAIN can be performed in the CHANNEL EDIT section. Here we will explain channel operations
using the CHANNEL EDIT section.
fig.ChEditSection.eps
Operations using the CHANNEL EDIT section
LAYER section
CHANNEL EDIT section
Fader module section
[SEL]
1.
In the LAYER section, press [AUX/MTX] to assign the
input channel to the fader module section.
2.
Press a [SEL] button to select the input channel that you
want to edit.
fig.ScrChAux.eps
The CHANNEL DISPLAY screen will appear.
Each time you press the MAIN [SEL] button, it will select the MAIN L,
MAIN R, or MAIN C one after another.
If you clear the check mark for the CHANNEL SELECT item
“CHANNEL DISPLAY follows CH SELECT button” in User
Preference (p. 141), pressing a [SEL] will select the channel
without showing the CHANNEL DISPLAY screen. In this case, you
can access the CHANNEL DISPLAY screen by pressing the [CH
DISP] in the CHANNEL EDIT section.
Selecting the channel
Even if you operate the knobs of the CHANNEL EDIT section
without accessing the CHANNEL DISPLAY screen, the value
of the currently-operated parameter is shown in the sub-
display area.
M-480_e.book 57 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
