95
Metering
Metering
Viewing the channel strip of the channel layer
To view the channel strips, use the LAYER VIEW tab of the METER
screen.
fig.ScrMeterLayerGuide.eps
Channel strip
This shows the level and principal parameters of the
channels.
Channel strip operations
You can move the cursor to the buttons, knobs, and faders of the
channel strip, and use the value dial to edit them.
fig.ScrMeterStripGuide.eps
Channel number/name
This indicates the channel number and name.
+48V button (CH1–48, RTN1–6)
This turns +48V phantom power on/off for the input jack
that is patched to the channel.
PAD button (CH1–48, RTN1–6)
This is an on/off switch for the pad of the input jack that is
patched to the channel. If this is on, the input sensitivity of
the preamp will be lowered by 20 dB.
ø (phase) button
This inverts the phase of the audio signal. The phase will be
inverted if this is on, and will be normal if this is off.
Preamp gain knob (CH1–48, RTN1–6)
This adjusts the preamp gain for the input jack patched to
the channel, in a range of -65 dBu– -10 dBu (or a range of -45
dBu–+10 dBu if PAD is on).
The preamp gain is not a continuous control, it is digital with
stepped control. In certain situations artifact noise may occur
when changing preamp gain. This is normal.
Gain Reduction
This indicates the amount of gain reduction:
EQ graph
This indicates the approximate response of the 4-band EQ.
S button
This turns SOLO on/off for the channel.
M button
This turns MUTE on/off for the channel.
Meter
This indicates the level of the channel.
Pan/Balance knob
This adjusts the pan of the channel. For stereo-linked AUX
channels and MTX channels, this adjusts the left/right output
balance.
Fader
This adjusts the fader of the channel.
LAYER VIEW tab
1
1
2
3
4
5
6
7
8
1
9
10
11
12
1
2
3
G
Gate/expander (CH1–48)
C Compressor (CH1–48)
L Limiter (AUX1–16, MTX1–8, MAIN L/R/C)
4
5
6
7
8
9
10
11
12
M-480_e.book 95 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
