189
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1.
Access the M-48 LIBRARY popup.
2.
In the library list, select the library item that you want to
recall.
3.
Use the recall parameter select buttons to select the
parameters that you want to recall.
4.
Press [F4 (RECALL)].
fig.ScrM48LibRecall_Conf.eps
A message will ask you to confirm the recall operation.
5.
Press [F8 (RECALL)]; the recall operation will be executed,
and a status message will indicate the progress of the
operation.
When the recall is completed, the message will disappear.
Pressing [F7 (CANCEL)] will cancel the operation.
The confirmation message in step 4 will not appear if the user
preference CONFIRMATION select button “SCENE/LIB RECALL” is
unchecked.
1.
Access the M-48 LIBRARY popup.
2.
In the library list, select the library item that you want to
clear.
3.
Press [F6 (CLEAR)].
fig.ScrM48LibDel_Conf.eps
A message will ask you to confirm the operation.
4.
Press [F8 (CLEAR)].
The library item you selected in step 2 will be cleared.
Pressing [F7 (CANCEL)] will cancel the operation.
Recalling settings from the M-48 library
Clearing an M-48 library item
Saving/loading USB memory
This loads or stores all data saved in M-48 units as M-48 project
files on USB memory.
1.
Access the M-48 MANAGER popup.
2.
Press [F5 (LOAD/SAVE)].
ffig.ScrM48LoaSave_Guide.eps
The M-48 LOAD/SAVE popup will appear.
Target unit list
This list shows the M-48 units to which the load or save
operation will apply. The list shows the following items:
Project file list
This lists the M-48 project files that have been saved to USB
memory. You can specify the save-destination folder for the
project file, or specify the project file that you want to load.
The function buttons have the following operations:
Accessing the M-48 LOAD/SAVE popup
MARK
Add check marks to this column if you want
to load or save data for multiple M-48 units.
Pressing [ENTER] will add or remove the
check mark.
NO. Indicates the number in the list.
UNIT NAME Indicates the unit name.
2
1
1
[F1 (MARK ALL)]
Adds a check mark to all MARK fields of the
target unit list.
[F2 (CLEAR MARKS)] Clears the check marks from all MARK fields of
the target unit list. This will be on if any MARK
fields are checked.
[F3 (MAKE FOLDER)] Creates a folder in the project file list.
[F4 (NAME EDIT)] Accesses the NAME EDIT popup where you can
edit the name of the file or folder.
[F5 (LOAD)] Loads the project file selected in the project file
list (p. 191).
[F6 (SAVE)] Saves the data of the target unit (p. 190).
[F7 (DELETE)] Deletes the selected file or folder from the
project file list (p. 191).
[F8 (CLOSE)] Closes the popup.
2
M-480_e.book 189 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
