21
Explanation of the panels
Explanation of the panels
fig.FaderModSectGuide.eps
This section lets you control the 24 channels you selected in the
Layer section.
[SEL] buttons
Use these buttons to select the channel that you want to
control in the CHANNEL EDIT section or in the screen. The
[SEL] button of the currently selected channel will light.
[SOLO] buttons
These buttons turn solo on/off for each channel. The button
will be lit when solo is on.
“Using Solo” (p. 119)
Meters
These indicate the signal level of each channel.
“Editing the meter settings” (p. 96)
[MUTE] buttons
These turn muting on/off for each channel. The button will
be lit if mute is active.
Faders
These adjust the signal level of each channel.
fig.LayerSectGuide.eps
This section lets you select the channel layer that will be assigned
to the fader module section. The button of the currently assigned
channel layer will be lit.
[USER] layer button
This switches the USER layer mode on/off. It also calls up user
faders to the fader module section.
“Editing the user fader layers” (p. 139)
[AUX/MTX] layer button
This assigns AUX1–16 and MTX1–8 to the fader module
section.
[CH 25–48] layer button
This assigns CH25–48 to the fader module section
[CH 1–24] layer button
This assigns CH1–24 to the fader module section.
Fader module section
1
2
3
4
5
1
1
2
3
4
5
LAYER
section
Button
User Fader Layer
[AUX/MTX]
Layer 3
[CH 25–48] Layer 2
[CH 1–24] Layer 1
1
2
3
4
1
2
3
4
M-480_e.book 21 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
